SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White Multipurpose all in one elastic sealant and bonding adhesive Seals, Bonds and. 24 Jan SikaflexÆ FC. One part advanced polyurethane, elastomeric sealant/ adhesive. Description. Sikalex FC is a one-component, gun-grade. Specialist Construction Supplies for Repair, Maintenance, Building & Infrastructure. Sikaflex 11FC Data Sheet. Specification notes. Product: Sikaflex 11FC.
|Published (Last):||6 March 2004|
|PDF File Size:||19.27 Mb|
|ePub File Size:||13.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Install bond breaker cord in construction and expansion joints to prevent the sealant bonding to the base of the joint. When constructing siikaflex joint the following measurements have to be observed: Ambient and surface temperatures must be between 50C to C during application.
Sika Primer 3 ml and 1 litre containers. Masking tape should be applied where staining may occur.
SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White
The Company reserves itself the right to change the formulation of Sika products if so required by new research and development. Initial Cure Tack Free. Remove affected person to fresh air immediately and contact a physician.
Exercise care, as with handling any chemical construction product. Cured material can only be removed mechanically. All orders are accepted subject to our current terms of sale and delivery which are available on request. After the sealant has been applied to the joint, it can be smoothed using a spatula lubricated with diluted washing-up liquid Tensile Strength DIN 53 Flush immediately with water for 10 – 15 minutes and contact a physician.
Wash thoroughly with soap and water. Maximum joint width 30mm. Collect with suitable absorbent material.
SIKA Sikaflex 11FC All In One Adhesive Sealant Black Brown Grey White
Concrete grey, brown, white and black. Cut the plastic nozzle according to the desired bead width and then pierce the internal metal seal carefully to ensure that the passage of the sealant to the nozzle is not impeded.
Light weight building components Sheet metal enclosures, metal roof flashings Silos and claddings Pipe entries, unions and sleeves Ventilation ducts Pointing of windows – fixing of window sills Kitchen installations Floor and construction joints. Squeeze the trigger firmly to force the sealant through the nozzle.
Dispose of in accordance with local regulations. All surfaces must be clean, sound, dry and properly cured. Porous surfaces and surfaces subjected to submersion after cure, should be primed with Sika Primer 3. Elongation at Break DIN 53 Users should always refer to the most recent issue of the Technical Data Sheet for the product concerned, copies of which will be supplied on request, or can be accessed on the internet under www.
All primers should be applied as thinly as possible. The proprietary rights of third parties must be observed. Remove all loose material mechanically, with a wire brush, or by water or sand blasting as necessary.
Wash clothing before re-use. In practice, the differences in materials, substrates and actual site conditions are such that dc warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered.
Wash hands immediately after use. Priming is not usually necessary on new surfaces. Refer to consumption chart on last page of this technical data sheet. Install the cartridge directly into a normal skeleton gun. Keep sikfalex from open flames and high heat. Remove contaminated clothing immediately.
Safety goggles and chemical resistant gloves are recommended. Ensure that all traces of release agents, curing compounds and silicone treatments are removed, or perform a site test to determine whether adequate adhesion can be obtained.
Protect from direct sunlight. Contact Sika for further health and safety information.