Oracle Solaris Administration: IP Services Oracle Solaris 10 1/13 Information An IPMP configuration typically consists of two or more physical interfaces on the . “HI, I want to configure Link based IPMP on my solaris 10 machine. Could you please suggest the steps to configure it. Many thanks pradeepp “. 26 Jun This article describes how to configure link based IPMP interfaces in Solaris IPMP eliminates single network card failure and it ensures.

Author: Brazil Shaktilabar
Country: Algeria
Language: English (Spanish)
Genre: Automotive
Published (Last): 16 January 2008
Pages: 405
PDF File Size: 15.73 Mb
ePub File Size: 18.51 Mb
ISBN: 782-4-49258-327-9
Downloads: 93046
Price: Free* [*Free Regsitration Required]
Uploader: Kigazil

Place each physical interface into an IPMP group. Reboot the confiyuration after any changes to verify you have unique mac addresses now. IPMP requires the manual fixed network configuration mode resp.

How to configure Solaris 10 IPMP ?

Test address now configured on interface hme0; enabling probe-based failure detection on it. If you need additional data IP addresses you should add them as deprecated IP interfaces.

This site uses cookies. Whereas for the active-passive configuration i.

You should configure only test addresses on a standby interface. Make sure the NIC status are up and not in use. Its very clear and simple. For example, to configure hme0 with an IPv6 test address, you would type the conciguration Neither IP layer nor any further network path will be monitored, hence no test addresses to probe are required unlike the probe-based failure detection method. When the server is rebooted soparis configuration should take effect.

TOP Related  AYUDAS ERGOGENICAS PDF

Configure Link based IPMP in Solaris – Sun Solaris System Admin

IP Security Architecture Overview Configure the interface with a test address However, changes are lost across reboots. Troubleshooting Network Problems Tasks Similarly, if you configure as standby an interface that already has data addresses, these addresses automatically fail over to another interface in configurafion IPMP group.

Are you Looking for required Paid Training. Administering Network Interfaces Tasks.

Arena-Node1 ifconfig eg1 Check this link which is a basic networking cnfiguration Solaris Still this can be avoided by adding a standby parameter: You do not need to mark an IPv6 test address as deprecated to prevent applications from using the test address. Other Learning Articles that you may like to read. Three Days only Sale.

These physical interfaces might or might not be on the same NIC. Instead, these failovers might choose an active interface with fewer data addresses that are configured as UP than the standby interface.

TOP Related  ASPIRACION DE SECRECIONES EN PACIENTES INTUBADOS PDF

How to configure Solaris 10 Probe based IPMP

This can cause a hick-up in certain firewalls and load balancers. Configuring netmasks and default gateway in zones Solaris For example, to place hme0 and hme1 under group testgroup1you would type the following commands:.

You must mark an IPv4 test address as deprecated to prevent applications from using the test address. On the system with the interfaces to be configured, assume the Primary Administrator role, or become superuser.

DefaultFixed NCP is enabled; automatic network management is not available.

Than an ifconfig -a should do the trick. Consider the example of four VLANs, bgebgebgeand bge The group functions like an IP interface with data addresses to send or receive network traffic: Use the following syntax of the ifconfig command for configuring a test address: